Textron Jacobsen Ryan 544853C Manual Del Usuario página 12

5 OPERATION & CONTROLS
FIGURE 13
1. Rear Wheel Adjustment
2. Run sodcutter through a couple of cut-off cycles and
determine if the thickness is correct and the cut-off
blade is cutting correctly.
NOTE: A slight jumping of the handle is evident at each
cut, but excessive jumping indicates the cut-off
blade is entering the turf too far. Lower rear wheels
to correct jumping.
If sod is not being cut completely, raise rear wheels
slightly to lower cut-off blade.
When cut-off blade is correctly adjusted, the sod will
roll up slightly at each cutting stroke and there will be
a slight penetration into the soil below the sod with-
out excessive jumping of the handle.
10
METERING WHEEL ADJUSTMENT
LENGTH
OF
CUT
9' - 0"
(2,743 mm)
6' - 9"
(2,057 mm)
6' - 0"
(1,829 mm)
2182
4' - 6"
(1,372 mm)
3' - 0" (914 mm)
2' - 6" (762 mm)
2' - 0" (610 mm)
1' - 6" (457 mm)
1' - 0" (305 mm)
6' - 0" (1,829 mm) - Factory Setting
1. Use the previous Dog Arrangement Chart to deter-
mine appropriate position for specific sod lengths.
2. Select desired length of cut.
3. Read top of column to determine correct sprocket
and chain required for that cut.
4. Read across to determine number of dog(s) required
and their position on the dog wheel. See Figure 14.
1. Dog Wheel (showing dog locations)
5. With first adjustments completed and engine run-
ning, position sodcutter at start of cut.
SPROCKET AND CHAIN NUMBER
Discontinued
516384 1992 & Prior
12T SPROCKET
18T SPROCKET
547026 CHAIN
Obtain No. 35 chain
100 LINKS W/CON
103 links w/con
1
1
1 - 5
1 - 4 - 6
1 - 3 - 5 - 7 1 - 2 - 4 - 5 - 6 - 8
1 - 2 - 4 - 5 - 6 - 8
Number and Position
of
Dog(s) on Dog Wheel
1
2
8
3
7
4
6
5
FIGURE 14
∗
∗
516386
locally
1
1 - 5
1 - 4 - 6
1 - 3 - 5 - 7