Sod Cutter With Walking Ram Auto Cut-Off - Textron Jacobsen Ryan 544853C Manual Del Usuario

4 SET–UP
8. Attach throttle cable to carburetor and secure with
existing clamp. Secure convoluted tubing to handle
using wire tie from loose parts bag.
9. Attach the cutting blade to the side arms. Secure
using six (6) 5/16-24 x 1" screws and flangelock nuts.
See Figure 4. Torque to 25 ft.-lbs. (34 N·m).
NOTE: If sod hold-downs are being used, install them at
this time. Refer to the installation instructions
included with the sod hold-down accessory Part No.
545637.
1
FIGURE 4
1. Cutting Blade
2. Side Arm
4.2 SOD CUTTER WITH WALKING
After the Sod Cutter has been assembled, as described
in Steps 1 - 7 in the Set-Up Instructions, continue with the
following instructions:
1. Attach metering wheel control lever to right side of
handle. Secure to handle using two (2) 1/4-20 x 5/8"
cap screws and locknuts. See Figure 5. Attach
adjuster links (Part Nos. 521804 and 518245) to
metering wheel.
6
2
4607
RAM AUTO CUT-OFF
FIGURE 5
1. Metering Wheel Control Lever
2. Attach the blade mount to cut-off blade using one (1)
3/8-16 x 1 1/8" screw, lockwasher and nut on each
end (for units with 16" and 18" blades). For units with
12" blade go to Step 3. Bevel on cut-off blade must
face the rear. See Figure 6.
1
2
FRONT
OF
UNIT
FIGURE 6
1. Blade Mount
2. Cutting Blade
3. Install cut-off blade w/mount, to cut-off ram using four
(4) 3/8-16 x 1 1/8" screws, lockwashers and nuts.
Torque to 40 ft.-lbs, (54 N·m).
1
5034
2