Charging The Shaver - Braun Syncro System Smart Logic 7526 Manual Del Usuario

6
A Shaver
Your Braun Syncro is supplied with a Braun
Clean&Renew™ (please see section B).
SmartLogic
The «SmartLogic» electronics inside your shaver ana-
lyzes your personal shaving patterns, and then adapts
the battery care and cleaning cycles to ensure optimal
performance.
Technical specifications:
• Wattage via low voltage cord: 7 W
• Power supply via mains adapter, input voltage:
100-240 V ~ / 50 or 60 Hz (automatic adaptation)
• Shaver input voltage: 12 V
Description
1 Foil protection cap
2 Shaver foil
3 Cutter block
4 Foil release button
5 Long hair trimmer
6 Switch

Charging the shaver

• First charging: Using the power supply cord set,
connect the shaver to the mains with the switch in
position «0» and charge it for at least 4 hours (plug
might get warm).
The SmartLogic inside your shaver automatically
monitors the condition of the batteries as well as the
charging/discharging processes and adapts them to
your personal shaving patterns.
• From now on, the SmartLogic inside your shaver will
ensure optimal care of the batteries. If, for instance,
it is your habit to never let the batteries get low, the
SmartLogic will recognize this, look for a pause
when you are likely to not use the shaver and com-
pletely discharge and then recharge your shaver to
recondition the batteries (every six months at the
most, and only when necessary).
• A full charge will give up to 50 minutes of cordless
shaving time depending on your beard growth.
However, the maximum battery capacity will only be
reached after several charging/discharging cycles.
7 Charging light (green)
8 Low charge light (red)
9 Pilot light
10 Shaver socket
11 Power supply cord set