Worx WG168 Manual Del Usuario página 10

ASSEMBLY
1. ASSEMBLY OF THE MAIN HANDLE
(See Fig. A1, A2)
Align and insert the shaft into the upper
housing until a click can be heard. Make sure
the grooves are correctly matched. (See Fig.
A1). Tighten the shaft locking knob in the
direction indicated to lock
NOTE: Make sure that the handle is
firmly locked in place.
2.ASSEMBLY OF THE AUXILIARY
HANDLE (See Fig. B1, B2)
Slide the auxiliary handle onto the grooves
of auxiliary handle support until a click can
be heard. And make sure the auxiliary handle
locking clamp is closed. (See Fig. B1)
NOTE: Make sure the handle is firmly
secured in place.
If the handle is loose then tighten the 2 side
screws. (See Fig. B2)
3. ASSEMBLY OF THE SAFETY GUARD
(See Fig. C1, C2, C3)
Remove the screw from the bottom of the
10
trimmer head - then attach the safety guard to
the housing.
Secure the guard in place by the refitting of
the screw.
Remove the line cutter protection tape.
(See Fig. C3)
NOTE: Make sure the Guard is firmly
secured in place.
OPERATION INSTRUCTIONS
WARNING! The charger and battery
pack are specially designed to work
together so do not attempt to use any other
devices. Never insert or allow metallic objects
into your charger or battery pack connections
because of an electrical failure and hazard will
occur.
1. BEFORE USING YOUR CORDLESS
GRASS TRIMMER
The battery pack included is shipped
UNCHARGED. You must charge before first use.
The battery charger supplied was designed to
2-in-1 Grass Trimmer/Edger
(See Fig. A2).
only charge the Li-Ion battery also supplied.
Do not use another battery charger.
2. CHARGING YOUR BATTERY PACK
The Li-Ion battery is protected against deep
discharging. When the battery is empty,
the machine will switch off by means of a
protective circuit: The trimmer head no longer
rotates.
In a warm environment or after heavy use, the
battery pack may become too hot to permit
charging. Allow time for the battery to cool
down before recharging.
3. TO REMOVE OR INSTALL BATTERY
PACK (See Fig. D1, D2)
Depress the battery release button to release
battery pack from your trimmer (See Fig. D1).
After recharging, insert the battery pack into
trimmer's battery port (See Fig. D2). A simple
push and slight pressure will be sufficient until
a click is heard.
NOTE: When removing the battery pack,
hold it firmly to avoid dropping and injury.
4. BATTERY STATUS LED'S (See Fig. E )
NOTE: The Status LED's will indicate the
battery condition when the button on the
battery is pressed.
The LED's constantly senses and displays the
battery condition as follows:
Press the button "POWERTEST" , the light
button is illuminated.
When the three green lights are illuminated,
the battery is in a highly charged condition.
When two lights (
battery is in a moderately charged condition.
When only one green light (
the battery charge is depleted.
IMPORTANT:
When only one light is illuminated,
your battery is overly discharged, even
though the trimmer may still be capable
of cutting grass. Continuing to operate
your trimmer with the battery in this
discharged condition may reduce the life
and performance of your battery.
5. SAFETY ON/OFF SWITCH (See Fig. F)
Your trimmer has two Lock OFF switches (3) to
) are illuminated, the
) is illuminated,
EN