Controls; How To Use - Vornado VMH350-AU Guia Del Propietario

CONTROLS

THERMOSTAT -/+
POWER ON/OFF
This heater has a dual display
feature and both displays are
synced. One display is integrated
into the carry handle. The other
display is located on the front of
the heater.
The displays illuminate when
powered on and as settings are
adjusted. After a selection is made
the displays dim after 20 seconds.
10 English

HOW TO USE

Before use, check appliance for visible damage. DO NOT USE THIS HEATER if there is evidence of damage. If any damage is found, contact the
Vornado Authorized Service Center.
1. Use integrated handle on top of heater for
lifting and carrying.
MAIN POWER SWITCH
2. Position heater so airflow is not obstructed.
MODE
High Heat (1500 watts)
3. Unwrap power cord from storage tray on back
Low Heat (750 watts) or
of heater. Plug power cord into standard
Fan Only
grounded wall outlet.
TIMER
4. Press the Power button
Fan Only
POWER INDICATOR LIGHT
on both displays. Set thermostat to desired
Red light illuminates to
temperature using -/+. SET TEMP numbers
indicate the heater is on.
will flash on both displays as you adjust.
Once the selection is made it will flash for five
seconds, become constant for five seconds
and then returns to room temperature. The
displays will then dim after 20 seconds. Default
REMOTE settings upon first use will be High Heat and set
CONTROL temperature of 24 degrees.
Convenience at
5. Set timer to automatically power the unit off by
your finger tips.
pressing
displays. Press
and select Mode or
. Room temperature will illuminate
one-hour intervals, up to 12 hours. User can
also use -/+ to select the amount of time.
After a selection is made or after five
seconds of inactivity, the number selection
. 0 will flash on both top and front
will stop flashing and become constant. It
to select the amount of time in
is then displayed for five seconds, before
room temperature is displayed again. To cancel
the timer operation, select 0 hours or hold
for three seconds.
The white indicator light on front display and
TIMER on top display will illuminate to indicate
the timer is on.
NOTE: To change between Celsius and
Fahrenheit, press and hold the "+" and heat
mode buttons at the same time for 3 seconds
until display shows desired setting.
COOL DOWN
When you power off your heater while in
High or Low heat mode, it automatically
enters a cool down routine in which the
heating element turns off and the fan
exhausts remaining heat. During Cool
Down, both top and front displays count
down before powering off completely.
11
English