Storage; Reset Heater; Troubleshooting - Vornado VMH350-AU Guia Del Propietario

STORAGE

During the off-season or after extended periods of non-use, you may
choose to store your heater. To ensure long life of the product, it is
recommended to store your heater by following these instructions:
Cleaning is recommended before storage.
1. Power off and unplug power cord, wrap cord and slide inside
storage tray on back of heater.
2. Cover, or place back in retail carton
if available. This prevents heater
from accumulating dust over time.
3. Store heater in cool and
dry location.
DISPOSAL
Dispose of all packaging
materials in an environmentally
responsible manner.
14 English

RESET HEATER

RESETTING YOUR VORNADO HEATER
Your Vornado Heater has a multilevel safety shut-off system designed
to prevent overheating. Overheating may occur when the inlets or
outlet are blocked. If this happens, the safety shut-off system cuts
power to the heater and you must manually reset the heater.
1. Power heater off, then unplug power cord.
2. Remove any obstructions.
3. Wait 5–10 minutes, allowing heater to cool down.
4. Plug in power cord and place heater in desired position.
5. Power heater On. Your Vornado Heater should now
function normally.
Note: If the safety shut-off system
repeatedly shuts off your heater or
if it will not reset after following the
above procedure, contact the Vornado
Authorzed Service Center.

TROUBLESHOOTING

PROBLEM POSSIBLE CAUSE AND SOLUTION
Unit fails to power on.
Unit is not plugged in. Plug power cord into electrical outlet.
Unit has overheated. Automatic Safety Shut Off has initiated. See RESET HEATER.
Internal tip-over switch has been tripped and safety shut-off system has cut power to heater. Place heater
on level surface. See SAFETY FEATURES.
If heater does not turn on, make sure the main power switch on the back of the heater is on.
Unit is damaged or in need of repair. Cease usage and unplug. Contact Consumer Service for assistance.
Unit is not producing
Ensure unit is set to High Heat and thermostat is set to highest temperature setting.
sufficient amount of heat.
Close all doors and windows to trap heat.
Allow unit to fully circulate heat throughout room; may take several minutes.
15
English