Assemble the CYLINDER (79) to the Cylinder caddy. See detail 12-A.
Attach the INLINE GAS GAUGE (80) to the fuel outlet valve. See detail 12-B.
Step
Attaching TYPE 1 fitting to the inline gas gauge. See detail 12-C.
12
Outlet Valve
Left side
of grill
12-A Set CYLINDER (79) in the cylinder caddy with the
outlet valve facing the left side of the grill. Tighten
the cylinder hold down bolt against the bottom
cylinder collar.
12-A
79
Outlet
Valve
12-B Insert the nipple of the INLINE GAS
GAUGE (80) into the cylinder's fuel valve
outlet as shown. Turn the regulator hand
wheel clockwise to tighten. No tools are
needed. The Hand wheel will come to a
complete stop when the connection is
secure and gas will not flow until a
positive seal is achieved.
12-B
Inline
Gas
Gauge
80
12-C Remove plastic protective cap from TYPE 1
nipple! Insert the TYPE 1 Nipple of the regulator
(27) into the Inline gas gauge as shown. Turn
the regulator hand wheel clockwise to tighten.
No tools are needed. The Hand wheel will
come to a complete stop when the connection is
secure and gas will not flow until a positive seal
is achieved.
WARNING:
and when attaching or replacing the L.P. gas
cylinder, insure that the gas supply hose is
free of kinks and/or damage and is at least
3" away from hot surfaces such as the grill
casting.
IMPORTANT!
T
O ENSURE PROPER GAS FLOW
CONTROL VALVES MUST BE
OPENING THE GAS CYLINDER VALVE
(Pg. 14)
12-C
27
TYPE 1
Nipple
79
During assembly of grill
,
BURNER
"OFF"
BEFORE
.