Genie Z-45 FE Manual Del Operador página 11

Primera Edición • Primera Impresión
Z-45 DC
31060
31060
DANGER
Tip-over Hazard
Altering or disabling sensors
or limit switches can result in
machine tip-over. Machine tip-over
will result in death or serious injury.
Do not alter or disable sensors
and/or limit switches.
218559
Drive Direction Hazard
Machine can move in opposite direction of
Tip-over Hazard joystick movement. Movement in an unplanned
direction can result in death or serious injury.
Tipping over this machine will result in Crush Hazard
death or serious injury.
Contact with overhead obstructions
could result in death or serious injury.
Always match the color-coded direction arrows on
platform controls and drive chassis to determine Keep away from overhead obstructions
Only raise the platform when the machine direction of machine travel. Read and understand
or other possible hazards.
is on a firm, level surface. operator's manual.
28236
Cód. 1299207SPGT
219487
Platform Overload
Indicator Light
will stop and no functions will
operate.
Remove weight from the
platform until the light goes off
and then restart the engine.
Tip-over Hazard
Do not overload platform.
Platform overload will result in
death or serious injury.
31060 D
1288849
WARNING
Driving On a Slope
Do not drive machine on a slope that exceeds
maximum uphill, downhill or side slope rating.
Determine slope and side slope ratings for
machine and determine slope grade.
Maximum slope rating,
platform downhill
(gradeability):
Maximum slope rating,
platform uphill
Maximum
side slope rating
Runaway Hazard
Note: Slope rating is subject to ground conditions
Machine movement can occur
and adequate traction. Gradeability applies to
when a machine is operated
platform downhill configuration only.
on a slope that exceeds rated
Be sure boom is below horizontal
uphill, downhill or side slope
and platform is between non-steer
rating.
wheels.
A runaway machine could result
Move drive speed select switch to
in death or serious injury .
218559 B
machine on incline symbol.
114390
DANGER
Maintain required clearance.
Line Voltage
0 o t 5 0 K
Electrocution Hazard
This machine is not electrically insulated. Death or 50 to 200KV
injury can result from contacting electric power lines.
200 to 350KV
350 to 500KV
Always contact the electric power line owner. The
500 to 750KV
electric power shall be disconnected or the power
lines moved or insulated before machine operations 750 to 1000KV
begin.
114390 B
Z -45 FE • Z
®
Seguridad General
114397
Light flashing
indicates
the platform
is overloaded.
The engine
219487 A
1294856
Maximum allowable
wind speed:
28 mph / 12.5 m/sec
4WD: 45% (24°)
4WD: 25% (14°)
Tip-over Hazard
25% (14°)
Tipping over the machine will
result in death or serious injury.
1288849 A
82410
Required Clearance
V 1 0 t f 3 0 . m
15 ft 4.6 m
20 ft 6.1 m
25 ft 7.6 m
35 ft 10.6 m
45 ft 13.7 m
-45 DC
®
Manual del Operador
114397
219487
218559
1288849
114390
1294856
28236
82410
3
3
Maximum capacity: Maximum
662 lbs / 300 Kg allowable
side force:
Occupants and
90 lbs / 400 N
equipment must not
exceed 662 lbs / 300 kg
Maximum
occupants: 2
1294856 A
9