About The Controls; Remote Control - GE 66126283 Manual Del Propietario E Instrucciones De Instalación

About the controls on the air conditioner.
Appearance and features may vary.
Cool mode
Sleep mode
Set temperature
Auto mode
Power Mode
Air Conditioner Display and Controls
Controls
Power Pad
Turns the air conditioner on and off. (After
installing batteries in the remote control,
touch Power to operate air conditioner
settings.)
Mode
Use to set the air conditioner to FAN, COOL,
DRY and AUTO mode.
NOTE: If you have a Cool only model, heat
settings will not be active on your model even
though HEAT appears in the remote control
display.
Fan Speed Pad
Use to set the fan speed to LOW, MID or HIGH.
Temp Increase
Use to set temperature when in COOL mode.
Timer Increase
ON—When the air conditioner is off, it can be
set to automatically come on in 1/2–24 hours
(or 1/2–18 hours if setting with the remote
control) at its previous setting. Touch the
Timer Increase L /Decrease M pads to
set the timer in increments.
OFF—When the air conditioner is on, it can
be set to automatically turn off in 1/2–24
hours. Touch the Timer Increase L /
Decrease M pads to set the timer
in increments.
To cancel the timer, touch the Timer Increase
L / Decrease M pads until the display does
not show a time.
4
ON
OFF
Fan Speed
L M
/Decrease Pads
L M
/Decrease Pads
Low, Mid or
High fan
Dry or Auto
mode
Timer on/off
Set time
Temp Timer Sleep
Sleep
Touch to set the air conditioner to run for
1/2 to 24 hours (or 1–7 hours if setting with
the remote control) before it automatically
shuts off. Touch the Timer Increase L /
Decrease M pads to set the timer
in increments.
After the sleep timer is set, the set
temperature will automatically increase in
intervals to provide a comfortable sleeping
temperature.
To cancel the sleep mode, touch the Sleep pad
a second time or touch the Timer Increase L /
Decrease M pads until the display does not
show a time.
NOTE: The sleep timer will be cancelled if the
air conditioner is turned off or the Timer ON
pad is touched on the remote control.
Display
Shows the selected mode, fan speed, set
temperature or time remaining on timer.
The display will also show E4 and the unit
will signal when the water bucket is full.
The dehumidification (DRY or COOL mode)
process will stop but the fan motor will
continue to operate.
Timer On
Use on the remote control to turn the Timer on.
Then use the Time Increase L /Decrease M
pads to set the timer in increments. Touch
Timer On again to send time setting to unit.
Timer Off
Use on the remote control to turn the Timer off.
Clock
Use to set the time of day on the remote
control display. Touch Clock pad and then
the Time Increase L /Decrease M pads
to set. Touch Clock again to activate.
Mode
Temp
Fan
Timer On
˚F
Timer Off
Sleep
ON OFF AM PM
Clock
Power
Time Time

Remote Control