Parts List; Installation To Wood Stud Wall - PEERLESS Paramount PA730 Instalación Y Montaje

Before you begin, make sure all parts shown are included with your product.
Parts may appear slightly different than illustrated.

Parts List

Description
AA wall arm assembly
A M4 x 12 mm phillips screw
B M4 x 20 mm phillips screw
C retaining spacer
D #14 x 2-1/2" wood screws
E 5 mm allen wrench
F concrete anchor
G cable ties
H cable tie anchor
I 3/16" allen wrench
J 8-32 x 1/4" flat head screw

Installation to Wood Stud Wall

Using a stud fi nder, locate and mark the edges of the wood stud used in mounting this product. Use of an edge to
1
edge stud fi nder is highly recommended. Use a level to draw a vertical line down the center of the stud. Use wall
plate as template to mark center of holes along the vertical line. Drill two 5/32" (4mm) dia. holes 2-1/2" (64mm)
deep. Attach wall arm assembly (AA) to wall using two #14 x 2-1/2" fl at head wood screws (D) as shown in fi gure
1.1.
WARNING
• Installer must verify that the supporting surface will
safely support the combined load of the equipment
and all attached hardware and components.
• Tighten wood screws so that wall plate is fi rmly at-
tached, but do not overtighten. Overtightening can
damage the screws, greatly reducing their holding
power.
• Never tighten in excess of 80 in. • lb (9 N.M.).
• Make sure that mounting screws are anchored into
the center of the stud. The use of an "edge to edge"
stud fi nder is highly recommended.
PA730
Qty. Part #
1 095-P1709
4 504-9013
4 504-9020
4 590-5005
2 520-1202
1 560-9640
2 590-0320
2 560-9711
2 590-1290
1 560-0071
2 520-1622
G
AA
A
PA730-S
Part #
095-4709
504-2013
504-2014
590-5003
520-2165
560-9640
590-0320
560-2004
E
590-1290
560-0071
520-2622
H
AA
3 of 20
B C
I
J
WOOD STUD
D
fi g. 1.1
ISSUED: 06-18-07 SHEET #: 095-9269-6 02-15-12
D F
Skip to step 2.