Cord Management - PEERLESS Paramount PA730 Instalación Y Montaje

Cord Management

Attach cable tie anchor (H) to top or bottom of wall arm (AA) using screw (J) as shown in fi gure 3.1. Secure
3
cables to wall arm (AA) using cable tie (G) as shown in fi gure 3.2.
J
AA
H
J
NOTE: Adjustment points (socket screws) are factory torqued for optimal performance. This factory torque setting is
recommended to prevent the display from slipping over time. If more or less tension is desired follow this optional
step. You may not achieve optimal torque value if factory torque settings are adjusted.
If more or less tension is desired in the tilt mechanism, do the following:
• To adjust tilt, insert a fl at head screw driver into slot and remove cap covering the socket screw. Tighten or loosen
socket screw no more than half a turn using 5mm allen wrench (E) as shown in detail 1.
• To adjust roll, remove snap caps covering the 10-32 nylock nuts as shown in detail 1. Loosen 10-32 nylock nuts half
a turn and adjust roll position. Retighten 10-32 nylock nuts after display is in desired roll position.
• Do not loosen socket screws or nylock nuts to the point they become disengaged from the mount. Doing so may
cause the display to fall.
If more or less tension is desired in the arm pivot points, do the following:
• To increase tension, turn socket screw clockwise with 3/16" allen wrench (I).
• To reduce tension, turn socket screw counter-clockwise with 3/16" allen
wrench (I). Do not turn more than half a turn.
H
fi g. 3.1
OPTIONAL
DISPLAY
CABLES
WARNING
SOCKET
SCREW
DETAIL 1
6 of 20
All other brand and product names are trademarks or registered trademarks of their respective owners.
G
fi g. 3.2
SLOT
SOCKET SCREWS
ISSUED: 06-18-07 SHEET #: 095-9269-6 02-15-12
© 2012, Peerless Industries, Inc. All rights reserved.
10-32
NYLOCK
NUT
SNAP CAP
Peerless Industries, Inc.
2300 White Oak Circle
Aurora, Il 60502
www.peerlessmounts.com