Reassemble The Cooktop - Thermador PRD304WHC/U Instrucciones De Instalación

Reassemble the Cooktop

1. Reinstall the heat shield, if applicable.
2. Reinstall the spill trays.
3. Reinstall the Flush Island Trim with T-20 Torx screws.
4. Reinstall the burner pedestals.
5. Set the burner bases back on the burner pedestals.
6. Use a 16 mm Hex head bit for burners labeled 'D' or
'F'. Use a 9 mm hex head bit for burners labeled 'B' to
secure the burner venturi to each burner base.
TIP: If a 16 mm hex head bit is not readily available, a
5/8'' hex bit can be selected. Alternatively, a bolt with
5/8'' head either "double-nutted" or tightened into
the chuck of a power driver can be used.
7. Replace burner caps and grates.
Page. 9