Burner Conversion To Lp Instructions; Before You Begin; Conversion Preparation; Disassembling The Cooktop - Thermador PRD304WHC/U Instrucciones De Instalación

Burner Conversion to LP Instructions

Before You Begin

CAUTION
BEFORE PROCEEDING WITH THE CONVERSION,
SHUT OFF THE GAS SUPPLY TO THE APPLIANCE
PRIOR TO DISCONNECTING THE ELECTRICAL
POWER.
CAUTION
When connecting the unit to propane gas, make
certain the propane gas tank is equipped with its own
high pressure regulator. The maximum gas pressure to
this appliance is not to exceed 14.0 inches water
column from the propane gas tank regulator.
Tools Needed
• Scissors
• T-30 and T-20 Torx screwdriver
• 16 mm and 9 mm Hex head bits
• 1/4'' nut driver
• 7 mm or a 9/32" socket or wrench
• Flat-head screwdriver, 1/8'' blade
LP Gas Conversion Kit Items Included
Description
Foam Tape, 1" piece
Conversion Label
Burner Orifice 073
Burner Orifice 115
Burner Orifice 105
Burner Orifice 090
Page. 5
PALPKITHW5
(305 models PALPKITHW
only)
1 1
1 1
2 —
1 3
1 3
1 —
LP Conversion Preparation
1. Shut off the gas supply to the appliance prior to
disconnecting the electrical power.
2. Cut a 3/8'' long piece of the adhesive foam tape.
Place foam tape over the edge of the nut driver used
to replace the burner orifices, as shown below.

Disassembling the Cooktop

IMPORTANT: Ensure that the power is turned OFF at the
breaker and the gas supply is turned OFF.
1. Remove the cooktop grates and the burner caps.
2. Use a 16 mm Hex head bit for burners labeled 'D' or
'F'. Use a 9 mm hex head bit for burners labeled 'B' to
remove the burner venturi from each burner base.
TIP: If a 16 mm hex head bit is not readily available, a
5/8'' hex bit can be selected. Alternatively, a bolt with
5/8'' head either "double-nutted" or tightened into
the chuck of a power driver can be used.
The foam tape helps to retain
the orifice in the end of the nut
driver so it will not fall inside
the appliance during orifice
removal or installation.