Installing The Ovens Into The Cabinet; Reinstalling The Oven Door - Thermador ME301YP Manual De Instrucciones

en-us Installing the ovens into the cabinet
4.
CAUTION - Risk of injury! Follow the instruc-
tions below to prevent the latch from slamming shut
and pinching or cutting your hand.
Close the oven door until it catches on the hinge stop
levers, locking the hinges at the proper angle for door
removal.
The door will be open about 7" (18 cm) at the top.
a
5.
CAUTION - Risk of injury! The door is heavy.
D o not grip the door by the handle.
▶
U se both hands to firmly grip it by the sides.
▶
Maintaining the door angle, lift the door straight up
approximately 3/4" (2 cm) to unhook the hinges from
the slots and then pull it out towards you until the
hinges are clear of the oven housing.
Place the door in a convenient and stable location.
6.
Do not lay the door on its handle. This could cause
dents or scratches.
12

Installing the ovens into the cabinet

Installing the ovens into the cabi-
net
Follow these instructions to install your appliance in the
Installing the ovens into the cabinet
cabinet.
CAUTION
Risk of injury!
It is recommended to wear protective clothing during the
lifting process.
Wear gloves and long sleeves to protect hands and
▶
forearms from abrasion and potential scratches.
Take off watches and jewelry.
▶
Wear work shoes for foot protection.
▶
CAUTION
Risk of crushing!
DO NOT attempt to lift the unit by holding the oven's
¡
upper heating element.
Three people or proper equipment are needed to
¡
safely lift the combination oven into the cabinet open-
ing.
Requirements
You have verified the cabinet dimensions and electri-
¡
cal connections.
You have removed the oven door.
¡
→ "Removing the oven door from bottom hinge con-
ventional ovens", Page 11
"You have read the lifting recommendations"
¡
→ Page 10.
Position the unit on its packaging base close to and
1.
in front of the cabinet opening.
Lift or slide the unit into the cabinet cutout. Do not al-
2.
low the unit base to contact the flooring.
Guide the unit straight back into the cabinet cutout.
3.
Push the unit straight in until the oven trim is about
2" (5 cm) from being flush with cabinet wall.
Check that the electrical conduit cable is not crimped
4.
between the oven and the cabinet back wall. If neces-
sary, guide the electric conduit cable into the wall of
the cabinet access hole so it does not prevent the
unit from being pushed all the way into the cabinet
opening.
Check that the oven is straight and level.
5.
Push the unit all the way back into the cabinet cutout
6.
until the front edge of the unit is flush with the front of
the cabinet.
Install the supplied screws through the tap holes in
7.
the trim.
Refer to the enclosed SCREW INSTALLATION leaflet.

Reinstalling the oven door

Hold the door firmly in both hands. Grip it on either
1.
side, not by the handle.
Tilt the door back slightly towards you until it opens
2.
about 7" (18 cm) at the top.