Safety Notes; Functions; General Notes - Trix CidT Serie Manual De Instrucciones

Safety Notes

• This locomotive is to be used only with an operating system
designed for it.
• Use only switched mode power supply units and transfor-
mers that are designed for your local power system.
• This locomotive must never be supplied with power from
more than one power pack.
• Pay close attention to the safety notes in the instructions for
your operating system.
• Do not expose the model to direct sunlight, extreme changes
in temperature, or high humidity.
• The feeder track must be equipped to prevent interference
with radio and television reception, when the locomotive is
to be run in conventional operation. The 611 655 interference
suppression set is to be used for this purpose. The interfe-
rence suppression set is not suitable for digital operation.
6

Functions

• This model is designed for operation with H0 2-rail
DC systems (track according to NEM standards) with con-
ventional DC power packs.
• Analog 14 volts DC, digital 22 volts AC.
• This locomotive comes equipped with a Trix connector for
digital operation and can have the Trix locomotive decoder
66839/66849 installed in it.
• Trix motor vehicles must not be operated on digital systems
without an built-in engine decoder (Motor can be damaged!).

General Notes

• The operating instructions and the packaging are a component
part of the product and must therefore be kept as well as
transferred along with the product to others.
• When installing a digital decoder, the light bulbs already
installed in the locomotive must be replaced by the 610 080
light bulbs.
• Please see your authorized Trix dealer for repairs or spare
parts.
• http://www.maerklin.com/en/imprint.html
No warranty or damage claims shall be accepted in those cases where
parts neither manufactured nor approved by Trix have been installed in
Trix products or where Trix products have been converted in such a way
that the non-Trix parts or the conversion were causal to the defects and /
or damage arising. The burden of presenting evidence and the burden of
proof thereof, that the installation of non-Trix parts or the conversion in or
of Trix products was not causal to the defects and / or damage arising, is
borne by the person and/or company responsible for the installation and /
or conversion, or by the customer.