Troubleshooting - Style selections F15-I-005-071B Instrucciones De Ensamblaje

Chimenea eléctrica con repisa para sistema de audio y tv
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING

PROBLEM
Simulated flame
effect is dim or not
present.
The appliance
turns off and will
not turn back on.
The appliance does
not turn on when
the button is pushed
to "ON".
Remote control
does not work.
WARRANTY
The manufacturer warrants this item against defects in materials and workmanship for a period of one
(1) year from the date of original retail purchase. This warranty applies only to the original purchaser.
This warranty does not apply to any damage on the product by accident, misuse, or modified,
improper installation or by affixing accessories not produced by the manufacturer. The manufacturer
is not accountable whatsoever for product installation during the warranty period. There is no further
expressed warranty. The manufacturer shall not be legally responsible for incidental, consequential
or special damages arising at or in connection with product use or performance except as may
otherwise be accorded by law. The manufacturer disclaims any and all implied warranties.
POSSIBLE CAUSE
1. Dimmer control button
is set too low.
2. LED strip not
functioning.
3. "Flame wand" has come
loose from bracket.
4. "Flame wand" motor is
not functioning.
1. The overheat protection
device in the appliance
has been triggered.
2. House circuit breaker
has been tripped.
The overheat protection
device in the appliance
has been triggered.
Low batteries.
15
CORRECTIVE ACTION
1. Push the flame button, then
increase the brightness with the
up button.
2. Contact customer service center.
3. Remove screws holding back panel
in place and remove back panel.
Secure end of "Flame wand" back
into the support bracket.
4. Contact customer service center.
1. Turn all controls off, unplug the
appliance, allow the insert to cool
down for at least 10 minutes and
then plug back in and restart.
2. Reset house circuit breaker.
Turn all controls off, unplug the
appliance, allow the insert to cool down
for at least 10 minutes and then plug
back in and restart.
Replace all batteries in the remote
control.
Lowes.com

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

0781562

Tabla de contenido