Technical Characteristics - Nice neomat A Instrucciones Y Advertencias Para El Instalador

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 34
5) What to do if...
When the motor is switched on, the 2 beeps do not sound
and the Step-by-Step input does not control any movement.
Make sure the motor is powered with the correct voltage; if the pow-
er input is correct there is probably a serious fault and the motor
needs replacing.
After a radio command, 6 beeps are heard and the
manoeuvre does not start.
The radio control unit is unsynchronised, repeat the transmitter
memorisation process.
After a command, 10 Beeps sound and then the manoeu-
vre begins.
The auto-diagnosis of the memorised parameters has detected an
abnormality (incorrect positions, TTBUS address, wind and sun levels,
direction of movement). Check and repeat programming if necessary.
After a command the motor does not turn.
• The thermal protection might have triggered; in this case just wait
for the motor to cool down
• If a wind sensor has been connected, the set threshold might
have been exceeded
• You might try to switch the motor off and back on again; if the 2
beeps do not sound, there is probably a serious fault and the
motor needs replacing

6) Technical characteristics

NEOMAT A series tubular motors
Supply voltage and frequency
Current and power
Torque and speed
Continuous operating time
Work cycle
Protection class
Operating temperature
Precision (resolution) of the electronic limit switch : Greater than 0.55° (depending on the NEOMAT A version)
Electronic control unit
Signal voltage (step-by-step, sensors)
Wind sensor (anemometer) levels
Length of signal cables (step-by-step, sensors)
Radio receiver
Frequency
Coding
Range of ERGO and PLANO transmitters
Nice S.p.a. reserves the right to modify its products at any time without notice
8
a small troubleshooting guide!
: See the technical data on the label attached to each model
: See the technical data on the label attached to each model
: See the technical data on the label attached to each model
: Maximum 4 minutes
: Maximum 20%
: IP 44
: -10 ÷ 70 °C
: Approx. 24Vdc
: approx. 30 or 15 or 45 Km/h (with VOLO anemometer)
: max. 30m if near other cables, otherwise 100m
: 433.92 MHz
: 52 Bit rolling code FLOR
: Estimated 200 m in the open and 35 m inside buildings.
During the UP phase, before reaching the set position
(pos. "0", pos. "I"), the motor stops and then makes 3
attempts to start up again. This does not necessarily mean trou-
ble: if the programming of positions "0" "1" was carried out SEMI-
AUTOMATICALLY: when excessive strain is revealed during the
upward movement, the motor will switch off for approximately 1 sec-
ond, after which the system will attempt to complete the manoeuvre.
Check for any obstacles which may be obstructing movement.
The motor will stop before reaching the set position (pos.
"0", pos "I", pos. "1") during descent and ascent.
This does not necessarily mean trouble: in case of overload the
motor is switched off. Check to see if any obstacles are obstructing
movement.
The motor turns only if the control is manned.
If positions "0" and "1" have not been programmed the motor rolls
the shutter up or down only through manual control. Program posi-
tions "0" and "1".
Positions "0" and "1" have been programmed, but the
shutter moves down only if the control is manned.
The auto-diagnosis of the memorised parameters has detected an
abnormality in the motor position. Give the command to raise the
shutter and wait for it to reach position "0"

Publicidad

Tabla de contenido
loading

Tabla de contenido