Installation Instructions - Moen T5240 Manual De Usario

INSTALLATION INSTRUCTIONS

HANDLE SCREW
CARTRIDGE NUT
ESCUTCHEON NUT
DIVERTER VALVE
INSTALLATION OF DIVERTER TRIM
1. Remove cartridge nut and escutcheon nut from diverter valve.
2. Slide trim ring over diverter valve so that trim ring sets flat against bidet deck.
3. Place escutcheon over diverter valve.
4. Install and lightly tighten escutcheon nut. Install and firmly tighten cartridge nut.
5. Place handle on diverter valve stem and secure with handle screw. Press cap
into place on handle
INSTALLATION OF WASTE TRIM
1. Place seat cover (not included in chrome models) into Seat and push
carefully down. Be careful not to bend seat cover.
2. Screw drain plug head piece firmly onto drain plug base. Be careful not to
cross thread the part. Ensure that o-ring is correctly seated on head piece.
Rubber Gasket
Mounting Nut
INSTALLATION OF LIFT ROD ASSEMBLY
1. Thread mounting tube into the lift rod escutcheon. Place
the rubber washer below the lift rod escutcheon.
2. Insert the mounting tube through the bidet lift rod hole
from above. Place the metal washer on the mounting
tube. Thread the mounting nut onto the mounting tube
and tighten.
CAP
HANDLE
ESCUTCHEON
TRIM RING
Pop-up head piece
O-ring
Seat cover
(not included in chrome models)
Seat
Lift Rod Escutcheon
Mounting Tube
Metal Washer
INSTALLATION OF SHROUD ASSEMBLY
1. Apply 1/4" bead of plumber's putty (not supplied) around lower
flange of spray nozzle assembly. Hand tighten spray nozzle
shroud onto spray nozzle assembly.
Correct Disassembly
In order to remove seat cover, use screwdriver to
bend snap features back from the inside as
shown in picture. Do not try to lift seat cover with
tool from outside.
Lift rod knob
Escutcheon
Gasket
Steel washer
Nut
Lift rod
Lift and pivot
assembly
Spring clip
Pivot rod
3) Connect the pivot rod to lift rod strap using spring clip as shown above.
4) Place the drain plug into the full open position, flex the spring clip and adjust the lift
rod height so that the knob clears the faucet. Installation is not complete. If lift rod (5)
will not slide through the deck, check orientation of mounting bracket to ensure lift
rod hole is not blocked.
To disassemble waste assembly, reverse steps as listed above. In order to remove
seat cover, use screwdriver to bend snap features back from the inside as shown in
picture above. Do not try to lift seat cover with tool from the outside.
Shroud
Spray Head
Assembly
Incorrect Disassembly
Waste assembly
2