Installation Instructions - Moen 84781 Instrucciones Para La Instalación

INSTALLATION INSTRUCTIONS

CAUTION:
Always turn water OFF before removing existing faucet or disassembling the valve. Open valve handles to relieve water
!
pressure and insure that complete water shut-off has been accomplished.
Before installing new faucet make sure that the cartridge nuts are in place. The cartridge and cartridge nuts were properly installed and tested
before leaving the factory. Although it is unlikely, it is nevertheless possible that through the handling of the valve by any number of persons
the cartridge nuts may not be properly installed. This should be carefully checked at time of installation. If the cartridge nuts are not properly
installed, water pressure could force the cartridge out of the casting. Personal injury or water damage to the premises could result.
1
14
15
Mounting
Shank
1. Make sure that the mounting surface is
clean and dry. Orient deck gasket (17)
as shown, then assemble the deck
gasket to the lav assembly, pushing the
gasket around the mounting shanks
until it is seated inside the bottom lip of
the escutcheon (16).
B
1
3
4
6
13
7
1. Place plumber's putty (14) under seat (3).
2. Drop seat into drain opening in sink.
3. From underneath the sink, slide the bottom gasket (4), mounting washer (5)
and mounting nut (6) onto drain seat and hand tighten.
4. Fit seal (13) inside the drain tailpiece (7).
5. Install the tailpiece and hand tighten. Align the entire assembly so that the pivot
rod opening is facing the rear of the sink, hand tighten the mounting nut (6) until
snug.
6. Drop in drain plug (1) and install pivot rod in one of the following ways:
(A) VANDALPROOF: Prevents unauthorized removal of drain plug. Place pivot
rod seat (8) into opening of tailpiece as shown. Place the pivot rod (15) into the
opening and position the pivot rod through the drain plug hole as shown in
2
2. From under the sink, thread
mounting nut/washer (16) (large side
up) onto mounting shanks. Check
faucet position on sink top, and align
and match escutcheon gasket to
escutcheon, then HAND-TIGHTEN.
Connect supplies to mounting
shank. If using flexible supply lines,
thread onto faucet supplies finger
tight, then tighten with a wrench by
rotating one half turn.
2
1 Drain Plug
2 Lift Rod & Knob
3 Seat
14
11 4 Bottom Gasket
5 Mounting Washer
10
6 Mounting Nut
5
7 Tailpiece
8 Pivot Rod Seat
15
8
12
9
3
167
3. Install lever handle into handle hub. Be sure
the O-ring is in place on insert.
9 Pivot Nut
10 Lift Rod Strap
11 Lift Rod Strap Screw
12 Spring Clip
13 Seal
14 Plumber's Putty
15 Pivot Rod
illustration (A) above. Slide the pivot nut (9) onto the pivot rod and thread it snugly
onto the drain body, be careful not to overtighten.
(B) EASY REMOVAL: For quick removal of drain plug for cleaning, follow
instructions above except position parts as shown in illustration (B) above.
7. With lift rod (2) in position on the faucet, insert the end into the lift rod strap (10)
and secure with lift rod strap screw (11).
8. Connect the pivot rod (15) to the lift rod strap using the spring clip (12) as
shown above.
9. Place the drain plug in the full open position, loosen lift rod strap screw and
adjust lift rod height so that the knob clears the faucet. Tighten the lift rod strap
screw. Installation is now complete.
1
15
(A)
1
15
(B)
2