Harbor Breeze URBANIA Manual Del Usuario página 9

FAN MOUNTING
2.
Insert downrod (A) through canopy (B), canopy
cover (K) and yoke cover (D). [Note: Canopy
cover (K) must be turned with the shiny side
toward the motor housing (E).] Thread wires
from motor housing (E) through downrod (A).
(Fig. 2)
Tip: Apply a small piece of electrical tape (not
included) to the ends of the wires before
threading them through the downrod (A).
Slip downrod (A) into housing yoke, align holes
3.
and re-install pin (N) and clip (O). Tighten
downrod (A) set screws and then tighten nuts.
Slide yoke cover (D) down until it rests on top of
motor housing (E). (Fig. 3)
Depending on the length of downrod (A) you
4.
use, you may need to cut the lead wires back to
simplify the wiring. If you decide to cut back the
lead wires, it is suggested that you do so in the
following manner:
Take the lead wires and make sure that you
have pulled them all the way through the top of
the downrod (A). Start at the TOP of the ball on
the downrod (A) and measure 8 in. of lead wire,
and then cut the excess wire off with wire cutters
(not included). (Fig. 4)
NOTE: If you do not cut back the lead wires,
Steps 4 and 5 are not necessary and you may
proceed to Step 6 instead.
2
B
D
3
N
E
4
9
Electrical
Tape
A
K
A
D
O
Set
Screw
A
Ball