Using The Timer Function - Chicco MEC-6126 V Manual De Instrucciones

(fixed light) to signal the start of the warm-up cycle.
The warm-up cycle countdown time can be seen on the display. At the end of this cycle, a visual signal will appear on
the display (00 blinking) and the "ON/OFF" button led will turn to green. In addition, the appliance will beep 5 times to
indicate the food is ready.
5 On removing the bottles and/or baby food jars from the bottle warmer, dry them carefully before feeding your baby.
On removing the bottles and/or baby food jars from the bottle warmer, dry them carefully before feeding your
baby.
6. Press and hold the ON/OFF button (e) for about 3 seconds to switch the bottle warmer OFF. Disconnect the plug
from the mains and the connector from the appliance.
WATER LEVEL REQUIRED FOR WARM-UP CYCLE
Starting
temperature
NOTE: the amount of water indicated for the warm-up cycle refers to the Chicco Step Up line feeding bottles and 80 ml
jars. When using it for the Chico Well/Being feeding bottles, use the same amount of water checking the temperature
carefully at the end of the warm-up cycle. If the food is not hot enough, repeat the warm-up cycle.
STANDARD WARM UP TIMES (in minutes)
Starting
temperature
NOTE: the recommended warm-up cycle times refer to the Chicco Step Up line feeding bottles and 80 ml jars.
Warm-up times can vary quite considerably for feeding bottles of a different type/size/material than the Step Up line
version and different sizes of baby food jars than those indicated in the chart.

USING THE TIMER FUNCTION

This feature can be used to warm-up the food in advance (up to 1 hour before).
Follow the instructions in parts 1, 3 and 3 of the USER INSTRUCTIONS.
4. Press the "Timer" button (d) until you reach the time interval within which the contents should be ready.
Time intervals: 15 min; 30 min; 45 min; 60 min.
5. Press the ON/OFF button (e) to start the selected cycle.
The led above the button will go red and blink until the actual warm-up cycle begins. The red led will remain fixed from
start to finish of the warm-up cycle.
The warm-up cycle countdown time can be seen on the display.
At the end of this cycle, a visual signal will appear on the display (00) and the "ON/OFF" button led will turn to green. In
addition, the appliance will beep 5 times to indicate the food is ready.
Example: warming up a Step Up feeding bottle (150ml, ambient temperature) with the timer function ON (15 minutes):
• Select the capacity 150 ml (b.)
• Select the start temperature ❄ (c.)
• Press the "Timer" button (d) to select the 15' time interval
Feeding
bottle –
150 ml
20°C
5°C
-18°C
Feeding
bottle –
150 ml
20°C 3.5 min
5°C 5 min
-18°C 13 min
Feeding Bottle (capacity) or jar
Feeding
bottle –
250 ml
20ml
40ml
Feeding Bottle (capacity) or jar
Feeding
bottle –
250 ml
4 min
6 min
18 min
11
Feeding
bottle – Baby food jar
330 ml
40ml
80ml
60ml
Feeding
bottle – Baby food jar
330 ml
5.5 min 7 min
8 min 8.5 min
24 min 19 min