Chicco MEC-6126 V Manual De Instrucciones página 9

DIGITAL BOTTLE WARMER
GB
Dear customer,
We thank you and congratulate you on your choice. This stylish and user-friendly Digital Bottle Warmer allows you to
quickly warm-up your baby's food to the temperature you require, in a few minutes without any fuss and bother. The large
display and acoustic signals allow you to easily monitor the entire warm-up cycle. The bottle warmer comes with its own
support for use with smaller bottles and jars of baby food.
* approx 37°C. Chicco recommends you always check the temperature of the contents before giving them to children.
Before using this bottle warmer, please read these instructions carefully and keep them for future reference.
PACK CONTENTS
- DIGITAL BOTTLE WARMER
- Homogenised jar/feeding bottle support
- Power Cable
- User and Instruction Manual
WARNING!
- The product is not a toy and is destined for domestic-type use only. Never use it for purposes other than those
indicated in the instruction manual; all other use is to be considered improper and therefore hazardous. The
bottle warmer must only be used following the user instructions carefully.
- Do not leave the appliance, its accessories and any packaging materials (plastic bags, cardboard boxes, etc.) within the
reach of children as they are not toys and can be hazardous.
- This appliance is not intended for use by people (children included) with reduced physical or mental capacities, or with
insufficient experience or knowledge, unless under the supervision of a person responsible for their safety, or if instructed
on how to use the appliance.
- Children should be kept under adult supervision to ensure that they do not play with the appliance. Never leave the ap-
pliance unattended when it is switched on.
- Before using the bottle warmer, always check that the product and all of its components are not damaged. If in doubt, do
not use the bottle warmer and contact your local retailer or qualified experts.
- Ensure that the voltage and frequency (see voltage rating on the plate located underneath the appliance) correspond
to those provided by your mains network. The electrical system where the appliance is used must conform to all safety
regulations in force in the country the appliance is being used.
- Connect the appliance to a mains socket that is easy to access.
- Always place the bottle warmer out of reach of children, on flat, stable surfaces, and away from cradles and cots as the appli-
ance and the water inside heats up to a high temperature. Always pay maximum care and attention! Warning - burn risks.
- Never place the bottle warmer directly on or near hot surfaces, hobs, or onto delicate surfaces or surfaces that may be
sensitive to humidity and/or heat.
- Never use the bottle warmer without water in the heating tank.
- Use heat-resistant glass or heat-resistant plastic feeding bottles only: never use disposable feeding bottles.
- When using the product normally, always pay attention to the hot steam generated by the heated water to prevent
burns
- To prevent burns, during and at the end of the warming cycle, do not touch the upper surface of the appliance as this can
get very hot. Always remove the bottles and/or jars very carefully at the end of the warming up and/or stay-warm cycles
as they can get very hot.
Before feeding your baby, always check the temperature is not too hot (maximum 37°C).
- For hygiene-biological reasons, bottle warmers must be used for warming ready-to-eat meals, and never to cook them.
The ideal temperature when warming food is around 37°C . Never reheat food more than once, or for over an hour.
- The final temperature of the food and the warming cycle time both depend on the amount of food being reheated,
the starting temperature (ambient, fridge or freezer temperatures), the consistency of the mix, the selected warm-up
cycle, plus the type and size of the containers (plastic feeding bottles, glass feeding bottles, jars of baby food) and the
amount of water in the heating tank.
- Never move the bottle warmer when in use or when it still contains hot liquids.
- After three minutes from the end of the warm-up cycle, or three minutes of inactivity, the device will automatically
switch to standby mode; allow it to cool down completely before using it again.
- To disconnect the bottle warmer from the mains, check that the device is switched off and disconnect the power cable
plug from the mains socket. Do not pull the power cable or the appliance to unplug the appliance from the mains.
- Check that the power cable is always unplugged from the mains socket and that the bottle warmer is cold before moving
it, cleaning it, storing it, doing maintenance work or in between warming cycles.
9