Philips PHILISHAVE 860 Manual De Instrucciones página 9

Every six months
Fig. 21: Apply two drops of light machine oil to the teeth of
the trimmer.
Replacement shaving heads
Worn or damaged shaving heads must be replaced only with
original Philishave replacement heads type HP 1915L.
Environment
How to remove the built-in rechargeable battery
when discarding the appliance (fig. 22-26, page 50)
• Please note: You can also take the appliance to a Philips
Service Centre. The staff will be happy to help you.
- Remove the plug from the wall socket.
- Before removing the battery should be completely
empty. Let the appliance run until the motor stops.
- Push the trimmer slide (g) upwards (fig. 22).
- Unscrew the four countersunk screws at the back side of
the shaver. For this purpose you can use a small
screwdriver (width approx. 3 mm) or a Torx T-8 type
screwdriver (fig. 23).
- Remove the back plate of the appliance (fig. 24).
- Cut the two connector strips (fig. 25).
You will recongise the battery by the print NiMH.
Do not connect the appliance to the mains power after
the battery has been removed.
For Australian consumers
The rechargeable battey used in your Philishave appliance
is recyclable.
When discarding the shaver or when the battery requires
replacement, take the shaver to a Philips Service Centre or
authorised agent.
For the address of your nearest service centre or agent
please contact our Customer Information Centre on
telephone (008) 80 3312.
9