Brita RF-104 Instrucciones De Instalación página 5

• Shut off the water supply to the
refrigerator and shut off the
icemaker if applicable.
• Have a container handy to catch any
water that leaks during installation.
• Turn off water supply to the
refrigerator and dispense the water
from the refrigerator door until water
flow stops.
• This releases pressure from the
pipes before installation.
• Select the desired spot to install
the filter.
• Cut the cold water line cleanly.
No burrs.
• Hold the filter so that the end
marked "Outlet" is on the side
pointing toward the refrigerator.
• Insert the supply line side of the
cold water line into the inlet side of
the filter with endcap labeled "Inlet".
• Push the line in firmly.
• Give the line a gentle tug to be sure
that the line is properly seated.
RF-104 installation instructions
Step 1 Shut Off Water
materials and tools needed
bucket
WARNING
Attach inbound
Step 2
water line to filter
materials and tools needed
bucket
safety glasses
tape measure
!
DANGER
Supply line to Water Source
wet ends of tubing before inserting
cut squarely on both ends
do not bend or crimp
do not cut at an angle
Step 2 continued on next page >>
utility knife
To Refrigerator
5
Version 1.0C