Casals CPLI14K2 Instrucciones Originales página 8

- Before using this product for the first time, it
is important to make a full charge of batteries.
Inserting a bit:
- To open the drill's chuck (1), whilst
completely switched off, take firm hold of the
back part of the chuck and turn the front part
of the chuck counter clockwise.
- Insert the drill bit, screwdriver bit, or other
tool/ accessory required for the task, into the
chuck. In order to obtain a secure fastening
of the bit, insert the bit as far as you can into
the chuck. Take firm hold of the back part of
the chuck and turn the front part of the chuck
clockwise until it is firmly closed.
- In order to remove accessories from the
chuck, follow the same steps as indicated
previously but in reverse order
Screwing, drilling/unscrewing:
- To drill or screw, ALWAYS have the direction
set to clockwise (CW).
- To unscrew, set the direction to counter
clockwise (CCW).
- The appliance should not be in use when
changing the screwing direction.
How to select the direction of the rotation
(Fig A)
- Do not change the direction of the rotation
whilst the tool motor is in operation.
- The appliance has a selector (6), which
allows the direction of rotation to be changed.
Electronic speed control: (Fig A)
- The speed of the appliance can be
regulated according to the pressure exerted
on the on/off switch (7). This function is very
useful, as it makes it possible to adapt the
speed of the appliance to the type of work
that needs to be done.
8
- If the appliance works continuously at low
speed, working life of the appliance will be
reduced considerably.
Mechanical Speed change (Fig C)
1st speed: Move backwards the selector (12)
2ond speed: Move forwards the selector (12)
- The appliance should not be in use when
changing the speed
Select the function (Fig A, C)
Driving
- Turn the selector (10) until the arrow on the
appliance points to (
- Turn the selector (2) from (1) to (16) until the
desired result is obtained.
Drilling
- Turn the selector (10) until the arrow on the
appliance points to ( ).
Drilling with Impact Function
- Turn the selector (10) until the arrow on the
appliance points to ( ).
Use:
- Select the appliance function desired. (2)
- Turn the appliance on, by using the on/off
button (7)
Once you have finished using the appliance:
- Stop the appliance by releasing the on/off
switch.
- Remove the battery from the appliance if you
are not intending to use the appliance during an
extended period.
- Clean the appliance.
Cleaning
- Disconnect the appliance from the mains
).
and
clea
- C
mai
DO
OTH
- Cl
a fe
dry.
- D
acid
pro
- Do
the
par
- N
or a
wat
- If
of
and