Publicidad
V-Groover
S I M P L E X
Important Facts - Helpful Hints
1 Always be sure opposite lever is up while cutting, or blade may scratch mat board surface.
2 While cutting, always keep even, consistent downward pressure with right hand to ensure
most accurate cut possible.
3 Blades are dull when you feel a crunching or dragging during cut or when you notice frayed
V-Groover strips.
4 For maximum v-stop locking tension, make certain stop is firmly bottomed on backing sheet
before tightening.
5 Do not attempt to adjust blade depth. The result will cause all settings to be inaccurate.
6 Use practice mat board to determine overcut settings for your Simplex V-Groover.
7 If V-Groover channel is not sharp and free of mat board debris, clean out with the tip of the
blade.
8 After rotating mat for next cut, press down on stop foot to be sure that it is properly located
behind end of mat board.
Troubleshooting
Problem
Inconsistent overcuts
Blade tip breaks
Unparallel V-Groove
Rough, Frayed V-Groove
Warranty
Logan Graphic Products, Inc. ("Logan") warrants the SIMPLEX V-GROOVER to be free from defects in parts and workmanship for a period of one year
from the date of original purchase. Logan warrants that it will either repair or replace, in its sole discretion, any necessary replacement parts found to be
defective. Should the product need to be returned to Logan for repair or replacement parts, authorization for any return must come from Logan in writing.
Costs of returning the product to Logan, including insurances, shall be borne by the purchaser. Logan shall not be liable for any damages or losses, inci-
dental or consequential, direct or indirect, arising from the use of this product. This warranty extends only to the original purchaser and is not assignable
or transferable. This warranty is in lieu of all other warranties, expressed or implied.
L o g a n G r a p h i c P r o d u c t s I n c . , 1 1 0 0 B r o w n S t r e e t , W a u c o n d a , I L 6 0 0 8 4 T o l l F r e e 1 8 0 0 3 3 1 6 2 3 2 w w w . l o g a n g r a p h i c . c o m
Reason
Mat board may be out of square
Moving stops by hitting them too hard
Overcuts not adjusted properly
The blades are contacting each other or they
are exposed
Cutter not riding flat
Dull or broken blade tip
Solution
Cut mat board square
Hit stops gently
Re-adjust overcuts
1 Don't press both blade levers at the same time
2 Be sure both levers are up before beginning cutting
process
1 Keep even downward pressure on base during cutting
process
2 Guide rail must be flat on mat board
Change blade or blades
M O D E L 7 0 3
6
Publicidad
