Material Preparation - Homeright QUICK FINISH Serie Manual De Usario

MATERIAL PREPARATION

i Material to be sprayed may need to be strained to remove any impurities in the paint which may enter and
clog the system. Impurities in the paint will give poor performance and a poor finish.
Only thin the material if absolutely necessary to improve spray performance. Optimal spray performance
should be acheived simply by adjusting the various controls on the unit.
TO PREPARE THE MATERIAL
1.
Stir the spraying material thoroughly.
2.
Unscrew the cup from the nozzle.
3.
After the material has been properly thinned* and strained, fill
the container to desired level.
*THINNING THE MATERIAL
For certain spraying situations or desired finishes, thinning the
material may be desired. Make sure you adjust the material flow
settings for your specific material needs.
If thinning is necessary, use the proper solvent as specified by the
material manufacturer. Never exceed the thinning advice given
by the coating manufacturer.
Do not thin with materials that have a
flashpoint below 100°F (38°C).
1
2
3
5
ENGLISH