Sprayer Controls - Homeright QUICK FINISH Serie Manual De Usario

SPRAYER CONTROLS

NEVER trigger the gun while adjusting the
ears on the air cap. NEVER point the spray
gun at any part of the body.
MATERIAL FLOW CONTROL
i
The material flow control will be factory-set
at its lowest setting out of the box. Adjust
as needed.
•
Turn the knob out (counterclockwise) for less flow. Generally,
low material flow is needed for spraying smaller surface
areas, such as corners, lattice, or spindles.
•
Turn the knob in (clockwise) for increased flow. Generally,
high material flow is needed for spraying large surface areas,
such as fences and decks.
AIR CAP / PATTERN ADJUSTMENT
i
Adjust the spray pattern by turning the air
cap ears.
The air cap position will determine the
movement direction of the spray gun.
1.
Round pattern:
Use up and down, or side to side spraying motion,
depending upon the object being sprayed.
2.
Vertical pattern:
Use side-to-side motion during spraying.
3.
Horizontal pattern:
Use up and down motion during spraying.
2
AIR CAP EARS
1
=
=
=
3
=
=
=
7
=
=
=
=
=
=
=
=
=
=
=
=
ENGLISH