Evaporative Air Cooler - Taurus Alpatec R501 Manual De Instrucciones

ENGLISH

Evaporative Air Cooler

R501
DESCRIPTION
A Airflow outlet
B Wheels
C Cable housing
D Carry handle
E Water tank
F Refresh / Humidity
G OFF
H Speed 1
I Speed 2
J Speed 3
K Oscillation
L Ice packs
If the model of your appliance does not have the
accessories described above, they can also be
bought separately from the Technical Assistance
Service.
USE AND CARE:
- Fully extend the appliance's power cable before
each use.
- Do not use the appliance if its accessories are
not properly fitted.
- Do not use the appliance if the on/off switch
does not work.
- Do not use the appliance if it is tipped up and
do not turn it over.
- Disconnect the appliance from the mains when
not in use and before undertaking any cleaning
task.
- Store this appliance out of reach of children
and/or persons with physical, sensory or
reduced mental or lack of experience and
knowledge.
- Make sure that dust, dirt or other foreign ob-
jects do not block the fan grill on the appliance.
- Never leave the appliance connected and un-
attended if is not in use. This saves energy and
prolongs the life of the appliance.
INSTALLATION
- Be sure to remove all packaging material from
inside the appliance.
- Ensure that the fan is switched off from the
supply mains before start any installation or
assembly operation.
- Ensure that the appliance is level with respect
to the floor.
- The plug must be easily accessible so it can be
disconnected in an emergency.
ASSEMBLING THE WHEELS:
- To assemble the wheels, place the appliance
face down
- Fix the wheels into the holes located on the
appliance's base.
- Stand the appliance up again so as to check
that the wheels work properly.
INSTRUCTIONS FOR USE
USE:
- Extend the cable completely before plugging
it in.
- Connect the appliance to the mains.
- Guide the appliance to direct the flow of air in
the desired direction.
- Turn the appliance on, by using one of the
speed selection buttons (H / I / J).
OSCILLATION FUNCTION:
- The oscillation function makes it possible to
direct the flow from the apparatus so that it
automatically alternates over a range of 75º.
- To activate this function, press the (K) button.
- To deactivate this function, follow the proce-
dure for switching it on in reverse.
REFRESH / HUMIDIFY FUNCTION:
- To activate this function, press the (F) button.
- To deactivate this function, follow the proce-
dure for switching it on in reverse.
- Do not activate this function if there is no water
in the tank, or if the water level is below the
minimum.
- To cool the air, add the ice packs in the water
tank (L).