Festo SPC11 ASI Serie Guía De Referencia Rápida página 19

The dimensions refer to the standard sizes of service
S
units, proportional directional control valves and
drives.
If angled connectors cannot be avoided, use plug
S
connectors from the Quick Star series.
Do not use any restrictors in the supply lines.
S
Drive and measuring system
Use only the permitted combinations of valves, drives
S
and measuring systems approved of by Festo for the
SPC11.
Observe the permitted fitting positions.
S
Mount the measuring system symmetrical to the drive
S
stroke.
Mount the drive, the guide and the measuring system
S
free of play and flush in the direction of movement.
Specially for drives type DGP(I)(L)−...−...−KF or DGP−... with
suitable guide):
With bilateral air supply, open up completely the ad
S
justing screws for the internal end position cushioning.
Use a measuring system with the same stroke length.
S
Festo SPC11−...−ASI 0511b English 19