Regulatory Compliance - Clarity XLC3.4+ Guia Del Usuario

XLC7HS
Part 15 of FCC Rules Information
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Your equipment has been tested and found to comply with the limits of a
Class B digital device, pursuant to
Part 15 of FCC rules. These limits are
designed to provide reasonable protection against harmful interference in
residential installation.
This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that
interference will not occur in a particular installation; if this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, you are encouraged to try
to correct the interference by one of the following measures:
1. Where it can be done safely, reorient the receiving television or radio
antenna.
2. To the extent possible, relocate the television, radio or other
with respect to the telephone equipment. (This increases the separation
between the telephone equipment and the receiver.)
3. Connect the telephone equipment into an outlet on a circuit different
from that to which the television, radio, or other receiver is connected.
4. Consult the dealer or an experienced Radio/TV Technician for help.
Privacy of communications may not be ensured when using this phone.
WARNING: To maintain the compliance with the FCC's RF exposure
guideline, place the base unit at least 20 cm from nearby persons.
For body worn operation, this handset has been tested and meets the FCC
RF exposure guidelines when used with the Clarity accessories supplied
or designated for this product. Use of other accessories may not ensure
compliance with FCC RF exposure guidlines.
WARNING: Changes or modifications to this equipment not expressly
approved by the party responsible for compliance could void the user's
authority to operate the equipment.
14

REGULATORY COMPLIANCE

receiver