Krups XP3410 Manual Del Usuario página 16

PROBLEMS POSSIBLE CAUSES
Water flows through the Premature limescale build-
filter after an espresso has up due to particularly hard
been made. water.
Presence of marks in the The filter holder is clogged. Clean the filter holder with
cup.
The coffee is too fine.
The hinge on which the
filter holder is mounted is
clogged.
No crema on the espresso. The coffee is too old.
The coffee is not suitable
for espresso.
There is too little coffee in
the filter.
The water tank leaks when The valve at the bottom
carried. of the tank is dirty or
defective.
The valve is blocked by
limescale.
Water is leaking under the There's an internal leak.
appliance.
The drip tray has not been
fitted correctly.
The drip tray is overflowing. Empty and carefully rinse
The pump is abnormally There is no water in the
hot. tank.
26
SOLUTIONS
Descale your machine
according to the
instructions in the user
manual.
hot water.
Use a slightly more
granular coffee.
Clean the filter holder
mount and hinge with a
damp sponge.
Use freshly ground coffee.
Use finer ground coffee.
Add ground coffee.
Clean the water tank and
open the valve at the
bottom of the tank with a
finger.
Descale your machine
according to the
instructions in the user
manual.
Check that the tank is
fitted correctly. If the leak
continues, do not use
the appliance, contact an
approved service centre.
Check that the drip tray is
pushed to the back of the
appliance.
the drip tray and replace.
Fill the tank with water
and re-initiate the pump
(see paragraph: USING
FOR THE FIRST TIME).
Avoid emptying the tank
completely.
PROBLEMS POSSIBLE CAUSES
The espresso leaks over The filter holder is not
the edges of the filter. positioned correctly.
The rim of the filter holder
is encrusted with coffee
grounds.
The soft
positioned incorrectly.
Your espresso tastes bad. The appliance was not
rinsed
descaling.
The appliance doesn't The pump
work deactivated due to a lack
of water.
The removable water tank
has been fitted incorrectly.
If it is not possible to identify the cause of a malfunction, please contact an approved
service centre. Never disassemble the appliance. (if the appliance has been
disassembled, the guarantee may no longer be valid).
ELECTRIC OR ELECTRONIC PRODUCT
AT END OF LIFE
We participate in the protection of the environment!
Your appliance contains a number of materials that can be reused or recycled.
Take it to a collection point or an approved service centre so that it can be dealt
with appropriately.
SOLUTIONS
Put the filter holder in
place and lock it (turning it
from left to right as far as it
will go).
Remove excessive coffee
grounds and clean the
grid through which water
passes with a
sponge.
capsule is Check that the
capsule has been inserted
correctly: the paper must
not protrude outside the
filter.
Rinse the appliance
correctly after according to
instructions and check the
quality of the coffee.
has been Fill the tank with water
and re-initiate the pump
(see paragraph: USING
FOR THE FIRST TIME).
Avoid emptying the tank
completely.
Position the water tank
correctly.
damp
soft
the
27