HumanTechnik lisa Instrucciones De Servicio página 18

which is located on the right of the receiver,
to the required channel number. Use a small
screwdriver to adjust this switch.
All transmitters and receivers must be set to the
same channel.
Fig. setting the correct radio channel.
Operation
1. Switching the receiver on
Slide the on/off- switch to »on«. The portable
RF receiver is now ready to operate. After the
device has been switched on, each one of the
event indicators lights up briefly in sequence
and the receiver vibrates three times. This is a
self-test of the device and lets you know that it
is functioning correctly.
2. Event identification
The portable RF receiver displays the various
incoming signals as coloured lights and diffe-
rent sequences of vibration.
18 English