Kohler STERLING 2375 Serie Guia De Instalacion página 11

Top Surface
6. Assemble the Wall Surround
If the valving has not been installed, install it now following the valve manufacturer's instructions.
Position the shower wall panels upright on a clean, flat surface with the flanges aligned as shown.
Ensure the shower wall panels are both resting flat on the floor.
Apply a minimum 1/4" (6 mm) bead of clear mildew-resistant 100% silicone sealant on one of the
mating surfaces between the shower wall panels.
Reposition the walls together and assemble the bolt, washers, and nut at each location.
Tighten the fasteners using a 1/4" wrench and a ratchet with a 11/32" socket. Do not overtighten.
Remove excess sealant.
Attach a 1x2 x 72" (182.9 cm) stud to the back outer edge of each shower wall panel with panel
adhesive to provide a solid attachment for the wall jambs.
Sterling
Apply silicone
sealant here.
Glue 1x2 x 72"
(182.9 cm) stud to
back of each wall
using panel adhesive.
Back Side Shown
Washer
Bolt
Washer
3/8" (1 cm)
11
Washer
Nut
1x2 x 72" (182.9 cm)
Stud
1100676-2-F