Kohler STERLING 2375 Serie Guia De Instalacion página 15

Silicone
Sealant
10. Seal the Walls and Shower Receptor
NOTE: Follow the sealant manufacturer's instructions for application and drying time.
Silicone the joints between the shower receptor and the shower wall panels.
Silicone along the vertical joint between the two shower wall panels.
Silicone the joints between the shower receptor and the base board.
Silicone the joints between the shower receptor and the floor.
Allow the silicone sealant to dry according to the manufacturer's instructions.
Install any grab bars or towel bars to the bridging installed earlier. Follow the accessory
manufacturer's instructions.
11. Locate the Wall Jambs
Measure 38-1/8" (968 mm) (dimension "A") from the back shower panel to the front edge of the
shower base and mark with a pencil.
Position the wall jamb to the inside of the pencil mark on the shower base.
Using a level, plumb the wall jamb.
Mark the wall jamb hole locations on the wall surround with a pencil.
Sterling
Silicone
Sealant
Shower Receptor
Dimension A = 38-1/8" (96.8 cm)
15
Pencil
Wall Jamb
Level
A
1100676-2-F