Kohler STERLING 2375 Serie Guia De Instalacion página 23

Inside Handle
Spacer
Handle
Setscrew
Outside
Handle
Spacer
Etched
Logo
21. Install the Handles
CAUTION: Risk of injury or product damage. When reassembling the door handle assembly make sure
to re-install the provided spacers in the configuration shown in the attached view. The handles should not
be tightened to the tempered glass hard surfaces without the spacers or it may shatter.
NOTE: The handle comes pre-assembled and must be disassembled prior to installation on the shower
door.
Unscrew the non-logo handle from the pre-assembled handle assembly.
Remove the spacer from the handle setscrew.
Slide the assembled handle setscrew and handle assembly (logo facing the outside of the shower)
through the hole in the glass shower door.
Re-insert the spacer onto the handle setscrew.
Screw the other (non-logo) handle onto the handle setscrew.
Fully tighten both handles evenly making sure the logo is properly orientated.
22. Install the Threshold Seal
Trim the threshold seal to fit.
Orient the water dam toward the inside of the shower and press the threshold seal onto the bottom
of the glass door panel.
Sterling
Seal here,
outside only.
Bridge Member
23
Glass Door
Panel
Water Dam
Inside of
Outside
Shower
of Shower
Threshold
Seal
1100676-2-F