BGS technic 8385 Manual De Instrucciones página 29

If you use the device to work on Audi A6 and VW
Passat, following screen shows after the activation
is completed:
If the tool fails to open the brake pads, "Activation Failed! Please try again!" message comes up.
- Verify that the ignition is ON;
- Check if the brake tool's OBD II connector is securely connected to the vehicle's DLC;
- Check that the park brake is released;
- Turn the ignition off and turn it back on 10s later;
- Repeat the process.
If the "Activation Failed!" message does not go away, then contact your local distributor or the
manufacturer's customer service department for assistance. If a "The selected function is not
supported!" message shows on the display,
- Check that the park brake is released;
- Repeat the process.
3. If you do wish to go to set the thickness of
caliper, press Y button to continue.
If you do not wish to do the adaptation of caliper at
this moment, press N button or use UP/DOWN
button to select NO and then press Y to exit.
4. Use UP/DOWN button to enter new pad
thickness, and press Y button to
confirm.
If you want to quit the setting, press N button and a "Command Cancelled!" message comes up.
5. An "Adaptation Done!" message comes up on device screen indicating the setting is performed
successfully. If the setting is not carried out successfully, an "Adaptation Failed!" message shows.
Repeat operations above to try again.
6. Wait a few seconds or press any key to return.
Adaptation
The Adaptation is used to enter the new calipers thickness of rear brake calipers after changing brake
discs & pads on Audi A8 cars.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
8
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed