BGS technic 8385 Manual De Instrucciones página 33

1. To close the brake pads after finishing the
maintenance/service work on the brakes, use
UP/DOWN button to select Activate Brake from
Select Function menu and press Y button.
2. Wait a few minutes while the device is activating
the brakes. When they are activated successfully,
following screen shows:
If the tool fails to close the brakes, an "Activation Failed! Press any key to con." message shows.
3. Press any key to return to previous menu.
Change Brake Fluid
WARNING: Do not operate the brake pedal until you are prompted to!
Make sure the central lock is deactivated! Use extreme caution during the whole bleeding process as
the pressure of pump bleed screw will be up to 100 bar!
1. Connect a charger to vehicle battery.
2. Prepare at least 2.0 liters of brake fluid and pour the liquid into brake fluid accumulator.
3. Connect the fluid accumulator to brake's master cylinder with the accumulator tube.
4. Plug the device to vehicle DLC and turn ignition on.
5. Use UP/DOWN button to select SBC-Mercedes
from Diagnostic Menu and press Y button to
confirm.
6. Use UP/DOWN button to select Change Brake
Fluid from Select
Function menu and press Y button.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
12
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed