BGS technic 8385 Manual De Instrucciones página 34

Important: To complete the brake fluid change
process, make sure vehicle battery is fully charged
and is in good condition. The brake tool keeps
detecting battery voltage during the whole process.
Once the voltage is too low to support the
operation,
"STOP: Voltage at control unit SBC xx.xV"
message indicating battery low comes up.
If the voltage stays at a low level, the device is not able to proceed with the service work. So stop the
service by holding N button for at least 1 second, and an "Operation failed!" message comes up.
7. Follow onscreen instructions to complete the first phase of operation:
- Connect filling and bleeding unit.
- Set pressure: 2.0-2.5 bar.
- Wait until the pressure has built up.
- Open bleeder screw at rear left brake caliper.
- Hold bleeder hose tight.
8. If you wish to move to the second phase of operation, press Y button as instructed.
If you do not wish to continue the service, press N button to exit, and an "Operation failed!" message
comes up. You can exit the fluid change service at any phase of the operation with N button.
9. To complete the second phase of operation, do the following as instructed:
- Turn off filling and bleeding equipment.
- Wait until the pressure drops.
- Disconnect filling and bleeding equipment.
10. Press Y button to move to next phase.
11. To complete the third phase, do the following as instructed:
- Set pressure: 0.5bar.
- Wait until the pressure has built up.
12. Press Y button to move to phase 4.
13. Following instructions on device screen to finish the fourth phase:
- Reduce pressure at filling and bleeding unit to 0 bar.
- Turn off filling and bleeding equipment.
- Leave filling and bleeding unit connected.
- Wait until the pressure drops.
- If the filling and bleeding unit has a shutoff valve, close it.
- Switch on filling and bleeding unit.
14. Press Y button to continue with phase 5.
15. Follow onscreen instructions to finish the fifth phase.
- Set pressure: 2.0-2.5 bar.
- If present, open shutoff valve for filling and bleeding unit.
- Wait until the pressure has built up.
- Hold bleeder hose tight.
- The pressure at the bleeder screw is greater than 100 bar!
16. Press Y button to continue.
17. Follow onscreen instructions to finish the sixth phase.
- Close bleeder screw at rear rig ht brake caliper.
- Open bleeder screw at rear left brake caliper.
- Hold bleeder hose tight.
18. Press Y button to continue.
19. Follow onscreen instructions to finish the seventh phase.
- Close bleeder screw at rear left brake caliper.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
13
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed