BGS technic 8385 Manual De Instrucciones página 38

Whenever you operate the pedal too hard and the
pressure is raised beyond the specified range of
current phase, following screens come up
prompting you to repeat the process to try again:
12. Continue to operate the pedal gently to
increase the pressure to 9.5-10.5
bar and keep it for 5s.
Keep operate the pedal to increase the
13.
pressure to 19.5-20.5 bar and hold it for 5s.
14 Follow onscreen instructions to finish current
phase of operation:
- Release brake pedal.
- A strong brake pedal kickback indicates a
fault.
- Did brake pedal pulse weakly?
- If YES, press [Y] or gently actuate and then
release the brake pedal to continue.
- If NO, press [N].
15. Press Y button or gently actuate and then
release the pedal to continue, and the device
starts to communicate with the vehicle.
16. Use UP/DOWN button to view onscreen
prompts.
17. Press Y button and following screen shows:
18. Actuate the pedal gently to raise the pressure to 10-20 bar and keep it for 5s.
19. Follow onscreen instructions to complete operation of current phase:
- The fill level of the pedal travel simulator is in order.
- Release brake pedal.
- Check fill status of wheel brake circuit HZ2 (secondary brake circuit).
20. Press Y button or gently operate the pedal to continue, and the device
starts to communicate with the vehicle.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
17
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed