BGS technic 8385 Manual De Instrucciones página 32

2. A warning message comes up asking for your
confirmation.
If you do not wish to proceed to erase the codes,
press N button or use UP/DOWN button to select
NO and then press Y button to exit. A "Command
Canceled!" message shows up. Press any key or
wait a few seconds to return.
3. Press Y button to erase.
If the codes are cleared successfully, an "Erase Done!" message shows up.
If the codes are not cleared, then an "Erase Failure. Turn Key on with Engine off!" message
displays.
Deactivate Brake
WARNING: Deactivate the SBC system before carrying out any maintenance/service work on the
brakes such as changing of pads, discs and fluids.
Use proper tools to avoid the risk of body injuries of mechanics and technicians and damage to the
brake system. Make sure the vehicle is properly blocked before deactivation of the system.
1. To open the brake pads, use UP/DOWN button
to select Deactivate Brake from Select Function
menu and press Y button.
2. Wait a few minutes while the tool is deactivating.
When the brakes are deactivated successfully,
following screen shows:
If the tool fails to open the brake pads, a "Deactivation Failed! Press any key to con." message
shows.
3. Press any key to return to previous menu.
Activate Brake
CAUTION: The SBC system must be activated after finishing the maintenance/service work on the
brakes. Make sure the vehicle is properly blocked before activation of the system.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
11
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed