Yakima LoadWarrior Extension Manual Del Usuario página 2

If yOU ALREADy HAvE A
LOADWARRIOR INSTALLED:
• Remove it from your car.
• Disassemble the brackets
and set them aside.
• Separate the two basket
halves by removing the
screws at the joints.
•If you have fIxed bars:
If yOU HAvE "Q TOWERS"
OR bARS THAT CANNOT MOvE...
Continue to STEP
NEvER REPOSITION THE Q TOWERS!
LOAD bASkET ONTO RACkS.
Center basket over your rack's
crossbars.
ATTACH bOLTS AND kNObS.
insert bolts, engage the knobs.
1032389C-2/8
Remove the machine screws from
the ends of the Extension tubes.
• Insert the LoadWarrior Extension.
NOTE: Always replace
machine screws (from Extension) into
same holes when reassembling.
.
Q TOWER OWNERS:
ATTACH bRACkETS TO bASkET SECTIONS ONLy.
For first time bracket installation, refer to LoadWarrior instructions.
A friend
would make
this easier .
SECURE THE bASkET TO
THE bARS .
Lock the T-bolts.
You may find tapered screws
with your LoadWarrior.
MaChine
sCrews
DO NOT insert the tapered screws
from LoadWarrior into your
Extension's holes.
•If your bars Move:
If yOU HAvE bARS THAT CAN bE MOvED...
Move the bars apart to a range of 30" to 50".
TIGHTEN yOUR CROSSbARS
If yOU LOOSENED THEM.
(side view)
T-bOLT IS LOCkED when
the "T" of the bolt is turned
inside the hole:
Insert correct
screws into
each of the
taPered
joints and
sCrews
tighten them.
TIGHTEN
THE kNobS.