Calibration Of The Noon With An External Thermometer, P; Parameters Change Or Delete User Recipes, P; Extra Functions, P - 100%Chef noon Manual Del Usuario

NOON / User Manual
Select all the desired parameters "Temperature" and "Time".
Push SET (6).
Now we will introduce the recipe name: use the UP/
DOWN key to passing until the desired characters are
attained. To pass to the next character push the SET key (6).
To create spaces between words, push one more time
the SET key (6).
In case of modify any introduced character, we need
to pass and position up the wrong character, push
UP/DOWN key until the right character. To record this
definitive recipe, pus RUN/STOP (5). A signal sound will
give this indication too.
12 CALIBRATION OF THE NOON WITH AN
EXTERNAL THERMOMETER
The calibration is standard and easy with a regular
thermometer. It may also be calibrated by the user with
ease. In order to calibrate the probe with an external
thermometer, the user will have to switch on the
appliance with the switch and when the visual display
indicates "SYSTEM TEST", press the °C button (3).
The Noon temperature reading appears on the display.
With the buttons UP/DOWN (2) we will introduce the
temperature as it shows on the external thermometer.
Pressing SET will cause an acoustic indicator indicating
the unit is now calibrated with your thermometer.
13 PARAMETERS CHANGE OR DELETE USER RECIPES
In Order to CHANGE parameters or delete recipes input
by the use. All the recipes entered by the user can be
modified without creating any new recipes. It is as
simple as overwriting the old recipes that need to be
changed, deleted or modified. In order to delete the
recipes entered by the user and leave memory free,
press the PROG key (7) when starting.
The appliance appears in the "System Test Mode",
press the PROG key (7) when starting. The acoustic
device will sound indicating that your device is now
configured. Remember that following these steps will
eliminate any manual adjustments made to the Noon
including language, recipes and Fahrenheit.
EN
14 EXTRA FUNCTIONS
In this section we will explain some of the extra functions
and security features. These norms are applicable to
all the Noon models and they are an essential part of
reading this manual.
Security Thermostat
In case of overheating the security thermostat will stop
the heating resistance and pump automatically, and the
user will have to do the following:
- First disconnect the device through the general switch.
- Let the liquid cool down below the selected
temperature.
- Turn the device on again, and verify that the heating
resistance starts again.
- Find out the possible causes for the thermostat
reaction and if it is the case, contact the technical
service.
Water level detention
The equipment incorporates a security system that
stops at the minimum water level. When the water level
drops below the established security level, the system
informs the user with a continuous sound and light
signals and then stops the cooking process. One should
fill the tank or bath until it reaches the minimum level.
The equipment will function again instantaneously,
returning to the exact parameters that were previously
programmed before the security stop.
It is important that when we let the thermal circulator
run without any surveillance, it should be covered
with the lid or plastic film to avoid excess evaporation
and the stopping of the cooking process.
Memory and security parameters
An alternative memory system allows recovery of the
functions and programming before any temporary
failure in the power supply. The equipment is designed
in a way that if for any reason an energy failure stops
the device, once it is working again, its memory would
recover the last reading made before the blackout, (this
reading is made every 5 minutes) placing the same
parameters, mode, time, temperature and/ or exact
16
!