Tivoli Audio MUSIC SYSTEM TWO Manual Del Usuario página 7

5. SLEEP: With the Music System Two playing FM, AM, Bluetooth or an auxiliary device, briefly press to
begin the 20 minute Sleep timer. The corresponding green LED will illuminate while the Sleep
timer is active and the display will countdown the remaining Sleep time. The Music System Two
will power off automatically at the end of the Sleep cycle. Note RDS Text will not be displayed
in Sleep mode.
6. TUNE +/–: Press the Tune +/- buttons briefly to Auto Scan to the next station detected. See
"Auto Scan" under "Menu" on how to disable Auto Scan and tune stations manually.
BLUETOOTH: Press to activate Bluetooth wireless technology and follow the steps outlined
7.
in the "Bluetooth Operation" section.
8. CLOCK: Press and hold to set the hour first. A beep will confirm you are in the clock set mode.
Use the volume knob to select the hour (Figure 6) and then press the volume knob in to set and
cycle to the minutes (Figure 7). Adjusting the hour does not affect the minutes and vise-versa.
Repeat this process to set the year, month and the day (Figure 8, 9 and 10). Once set, press the
Clock button briefly to recall the date and time whenever RDS is displayed. When the date is
shown, only the month and day will show (not the year).
Fig 6, 7, 8, 9, 10
9. VOLUME/MENU/TREBLE: Rotate clockwise to increase the volume or counter-clockwise to
decrease the volume. The volume level is represented in numbers from 0 (no output) to 30 (maxi-
mum output). If the volume ever sounds distorted, reduce the level immediately. In any mode,
push and hold the knob to access the menu. See section marked "Menu". Push in and rotate
counter-clockwise to reduce the treble or clockwise to increase the treble. Press the volume
knob in to set or the setting will store automatically and the display will return to its previous
state. This knob is also used to adjust and enter selections (by pushing the knob in) when set-
ting the Clock and Alarms. Adjusting the volume during Snooze will cancel the Snooze mode.
10. AUDIO: Push briefly to cycle through Stereo, SpacePhase™ Wide mode, or Mono audio settings.
The SpacePhase™ Wide mode setting is designed to create a more expansive soundstage, while
the Mono setting reduces multiplex noise on weak FM stations, making otherwise unlistenable
stations listenable. Regardless of the previous audio setting, the SpacePhase™ Wide mode will
automatically engage each time the Music System Two is turned on.
EQ: To temporarily turn the EQ off, press and hold the Audio button. The display will show "EQ
Off" and a confirmation beep will sound. The EQ will engage again automatically the next time
the Music System Two is turned on. To keep the EQ off, press and hold the Audio button and the
display will show "EQ Always Off" and a confirmation beep will sound. The EQ will remain off until
"EQ On" is selected. The EQ differs from Audio in that it enhances lower frequencies primarily at
lower volume levels. We suggest the rear Bass level be set to the center detent position. Should
the bass ever sound distorted, immediately lower the bass level and/or volume. For more, see
the section marked "Getting the most from your Music System Two."
7 – ENGLISH