Power Input; Battery Compartment - Tivoli Audio MUSIC SYSTEM TWO Manual Del Usuario

4. AUX IN: To hear audio from another device such as a TV or MP3 player, connect said device's
audio output to this stereo input and set the Source button to AUX. Switching to the Auxiliary
position does not turn on the connected device. This stereo input accepts a 3.5 mm stereo male
mini connector. Note you may need to adjust the volume level differently for an auxiliary device
than the level used for radio listening.
5. MIX IN: Connect your computer's (or other device's) audio output to this input to hear its audio
mixed in with the tuner or auxiliary device if one is connected. The volume level of this input must
be adjusted at the source. This input accepts a 3.5 mm male stereo mini connector.
6. REC OUT: You can record from the Music System Two by connecting a cassette deck's audio
input (or other recording device) to this fixed level stereo output. The primary speakers will not
be muted when using this output. This jack accepts a 3.5 mm stereo male mini connector.
7. BASS LEVEL: Turn this control knob to the right to increase the bass volume level or to the
left to decrease the bass volume level. The subwoofer is designed to subtly augment the lower
bass frequencies, not overpower the sound. Tivoli Audio recommends setting this knob to the
center detent position. If the bass should ever sound distorted, immediately lower the bass level
control and/or the front volume control.
8. POWER INPUT: Connect the supplied power cord to this input and plug the cord into a wall
outlet not controlled by a switch. If the power cord is removed from the unit or unplugged from
the wall outlet, please wait 60 seconds before plugging the cord back into the Music System Two.
9. BATTERY COMPARTMENT: Properly install the included "AA" batteries to maintain the clock
and alarm settings during a power outage. Check the batteries annually. The display will show
"No Batteries" if there are no batteries installed or the batteries have no or low power. Dispose
of spent batteries according to your state/country's regulations. When operating on the battery
back-up power, the Music System Two's display and LEDs will not illuminate in order to conserve
power, but if set, the alarm will still sound at the designated time. In such a case, the tone will
sound instead of the radio to further conserve battery power.
Remote Control (Remove clear tab over battery before use)
In addition to duplicating most of the front panel controls, the
remote control adds the following functions:
1. SELECT MENU: Press and hold to enter the main menu
within each source mode and press briefly to select items
within the menu. Use pq button to navigate menu items.
For more, see the section marked "Menu".
2. DISPLAY: Press repeatedly to cycle through the informa-
tion available depending on the source mode you are in.
Controlling volume via the remote is performed using the pq
buttons, while AM and FM tuning is controlled using the Left
and Right arrow buttons (
When operating the remote control at close distances the dis-
play might pulse. This is normal and is a direct result of the
remote's ability to operate at greater distances.
When it comes time to replace the remote control's battery,
use a 3V Lithium Cell #CR2025, installed with the positive side
facing the bottom side of the remote.
9 – ENGLISH
).
1
SELECT
MENU
MUSIC SYSTEM TWO
2