11. SNOOZE/MUTE (TOP OF CABINET): When the Alarm activates, press this button to silence the
alarm for 7 minutes. The display will count down the remaining Snooze time. Adjusting the volume
level will cancel the Snooze mode. During normal operation, press this button to mute the audio.
The display will show "Muted". Press again to restore the audio output or adjust the volume level.
12. HEADPHONE OUT: Connect a set of headphones (not included) to this variable stereo output for
private listening. Plugging in the headphones will mute the primary speakers. The headphone's
volume is adjusted using the front panel volume knob. This stereo output accepts a 3.5 mm
stereo male mini connector. Avoid using headphones at high volume levels to prevent possible
hearing damage.
13. IR SENSOR: Receives signals from the included remote control. Do not obstruct this sensor.
Guide To Features (Rear Panel)
1. FM ANTENNA SWITCH: Switch between internal and external FM antennas. If an external
antenna is used, the switch should be in the External position. This switch has no affect on AM
reception.
2. EXTERNAL FM ANTENNA INPUT: In most cases FM reception will be improved by sliding the
included external FM antenna over this "F" connector and setting the antenna switch to External.
To avoid damage, when removing the FM antenna, never pull it by the white cord. Always grasp
the antenna's black connector firmly and pull it straight out. For more, see the section marked
"Reception".
3. EXTERNAL AM ANTENNA INPUT: Connect the supplied external AM antenna's 3.5 mm stereo
male mini connector. Assemble the integrated base, (Figure 13) and adjust for best reception
for each station. There will be no AM reception unless the AM antenna is connected. For more,
see the section marked "Reception".
Fig 13
8 – ENGLISH
9
7
4
5
6
3
1
2
8