Campbell Hausfeld XT051000 Manual De Instrucciones página 10

SAFETY INSTRUCTIONS (CONTINUED)
f.
g.
h.
i.
of flammable liquids or gases. Vapors could ignite by a spark and cause an
explosion which will result in death or serious personal injury.
repair, clearing a jam, or moving the tool to a new location.
few seconds of operation. Thus, the exhaust port must be covered with a
towel before applying air pressure. Failure to cover the exhaust port can
result in serious injury.
hand wrench. This can damage the tool by breaking parts in the ratchet
mechanism.
compressed air in the tool is discharged at the time the fitting or hose
coupling is disconnected. Do not use a check valve or any other fitting which
allows air to remain in the tool. Death or serious personal injury could occur.
from heat, oil and sharp edges. Replace any hose that is damaged, weak or
worn. Personal injury or tool damage could occur.
WARNING
!
legible. Warnings or warning labels are located on the tool magazine and
body.
Maintain the tool with care. Keep a cutting tool sharp and clean. A
properly maintained tool, with sharp cutting edges reduces the risk of
binding and is easier to control.
Check for misalignment or binding of moving parts, breakage of parts,
and any other condition that affects the tool's operation. If damaged,
have the tool serviced before using. Many accidents are caused by poorly
maintained tools. There is a risk of bursting if the tool is damaged.
Use only accessories that are identified by the manufacturer for the
specific tool model. Use of an accessory not intended for use with the
specific tool model increases the risk of injury to persons.
Selecting an appropriate tool actuation system, taking into consideration
the work application for which the tool is used.
Never use gasoline or other flammable liquids to
clean the tool. Never use the tool in the presence
Release all pressure from the system before
attempting to install, service, relocate or perform
any maintenance.
Always disconnect tool from the power source
when unattended, performing any maintenance or
After an air tool has been lubricated, oil will
discharge through the exhaust port during the first
When tightening, do not torque down the nuts
or bolts with the ratchet as typically done with a
Use of a whip hose prevents accidental triggering of
the tool when pressurized air is connected to the
system.
Always fit tool with a fitting or hose coupling
on or near the tool in such a manner that all
Never carry the tool by the air hose or pull the hose
to move the tool or a compressor. Keep hoses away
Do not operate or allow anyone else to operate the
tool if any warnings or warning labels are not
8