Safety Symbols - Campbell Hausfeld XT051000 Manual De Instrucciones

SAFETY INSTRUCTIONS (CONTINUED)
regulated pressure must not exceed 90 PSI. If the regulator fails, the pressure
90 PSI
delivered to the tool must not exceed 200 PSI. The tool could explode which
will cause death or serious personal injury.
Safety Glossary
This manual contains information that is very important to know and
understand. This information is provided for SAFETY and to PREVENT
EQUIPMENT PROBLEMS. To help recognize this information, observe the
following symbols.
IMPORTANT or NOTE: Information that requires special attention.

Safety Symbols

The following Safety Symbols appear throughout this manual to alert you to
important safety hazards and precautions.
Wear Eye
and Mask
Protection
WARNING
!
Warning label
SAVE THESE INSTRUCTIONS
DO NOT DISCARD
Use only a pressure-regulated compressed air source
to limit the air pressure supplied to the tool. The
Danger indicates an imminently hazardous situation
which, if not avoided, WILL result in death or serious
injury.
Warning indicates a potentially hazardous situation
which, if not avoided, COULD result in death or
serious injury.
Caution indicates a potentially hazardous situation
which, if not avoided, MAY result in minor or
moderate injury.
Notice indicates important information, that if not
followed, may cause damage to equipment.
Read Manual Risk of
First Explosion
O
CO
2
Do Not Use Use only a
Reactive pressure-
Gases regulated
compressed air
10
Wear Eye Risk of Fire
and Hearing
Protection