Campbell Hausfeld XT051000 Manual De Instrucciones página 13

GENERAL TROUBLESHOOTING GUIDE
SYMPTOM
Tool runs slowly or
will not operate.
Moisture blowing out
of tool.
Ratchet mechanism
slips or will not loosen
nut.
POSSIBLE CAUSE(S)
1. Grit or gum in tool.
2. No oil in tool.
3. Low air pressure.
4. Air hose leaks.
5. Pressure drops.
1. Water in tank.
2. Water in the air lines/hoses.
1. Ratchet mechanism is dirty.
CORRECTIVE ACTION
1. Flush the tool with air tool oil, gum
solvent, or an equal mixture of SAE
10 motor oil and kerosene. If air tool
oil is not used, lubricate the tool
after cleaning.
2. Lubricate the tool according to
the lubrication instructions in this
manual.
3a. Adjust the regulator on the tool to a
higher setting (If applicable).
3b. Adjust the compressor regulator to
90 PSI while the tool is running free.
4. Tighten and seal hose fittings, if
leaks are found.
5a. Be sure the hose is the proper size.
Long hoses or tools using large
volumes of air may require a hose
with an I.D. of 1/2 inch or larger
depending on the total length of
the hose.
5b. Do not use a multiple number of
hoses connected together with
quick connect fittings. This causes
additional pressure drops and
reduces the tool power. Directly
connect the hoses together.
1. Drain tank. Oil tool and run until no
water is evident. Oil tool again and
run 1–2 seconds.
2a. Install a water separator/filter.
NOTE: Separators only work properly
when the air passing through
the separator is cool. Locate the
separator/filter as far as possible
from the compressor.
2b. Install an air dryer.
2c. Anytime water enters the tool, the
tool should be oiled immediately.
1. Clean mechanism with air tool oil.
11