Campbell Hausfeld XT051000 Manual De Instrucciones página 4

u For best output, maintain pressure at the tool of 90 PSI.
u The longer your air hose the greater the pressure drop from compressor to tool.
If you are using a hose longer than 50 feet, consider upgrading to a 1/2 inch ID air
hose to ensure proper tool pressure.
u Failure to lubricate and maintain your air tools properly will dramatically shorten
their life. Use oil every time you use your air tool to lubricate, clean and inhibit rust
in one step. Campbell Hausfeld sells air tool oil under part number ST1270.
SPECIFICATIONS
Maximum PSI
CFM under load 100% duty
CFM no load 100% duty
SCFM under load 100% duty
SCFM no load 100% duty
Air Compressor Recommendation
Max Torque
Working Torque
Rated RPM (free speed)
Impact Speed (IPM)
Speed Control
Direction Change
Reverse
Forward
Gear Type
Bolt Capacity
Air Inlet
Minimum Hose Size
Anvil
Housing Material
Tool Weight
Tool Length
Tool Width
Tool Height
BEST PRACTICES
2
XT051000
90
1.9 CFM @ 90 PSI
3.4 CFM @ 90 PSI
14.3 SCFM @ 90 PSI
24.6 SCFM @ 90 PSI
4 gallon
75 Ft. Lbs.
0 - 50 Ft. Lbs.
320
1,600
Trigger
1
1
Pin Clutch
3/8 inch
1/4 inch NPT (F)
3/8 inch
3/8 inch
Composite
2.8 Lbs.
11-1/4 inch
2-1/4 inch
1-7/8 inch